EN
Vaega faapitoa uma
EN

Fale>tala>Lauiloa Saienisi Tusitusiga

O le a le mea e tatau ona mataala i ai i le gaosiga o faitotoʻa ma faʻamalama faʻamau faʻamau faʻatusatusa i le TPE overmolded fua faʻavae?

Taimi: 2020-05-25 Hits: 1

A: The melt index is different. The melt index of extrusion products is generally lower than that of injection molding. When the melt index is higher, it is not easy to build pressure when extruding, resulting in uneven discharge; in addition, the melt strength will be low. The case of broken bars. Other properties such as compression set, tensile strength, hardness, etc. are made according to customer requirements.